January 4, 2021

one.A connecting link of an O-ring Chain for common application is pre-coated with grease with the pins. Before connection, verify the grease within the surfaces of pins, and when the volume of grease is small, apply grease with bare hands. (If gloves are used, the grease will be absorbed by the gloves.)
Illustration: Once the connecting website link (I) of an O-ring chain for common application is
shipped, O-rings are fitted on the roots on the pins. Should the O-rings come loose due to vibration during transport, refit the O-rings in to your roots in the pins.
In this instance, be sure you return the grease collected at the roots of your pins to your central surfaces in the pins, extra at portion A than at portions B proven within the above illustration. (Portions A is worn as a consequence of sliding with the bushings.)
two.The chain might be most easily linked about the teeth of a sprocket. Engage the backlinks at both ends with the chain together with the sprocket teeth and fit connecting pins. Should the sprocket can be moved, the chain may also be connected around the loosened side.
three. Connecting procedure
one.Confirm that O-rings are attached for the roots of your pins.
2.In case the quantity of grease utilized over the connecting pins is compact, coat the pins with grease in the central portions.
3.Insert the connecting pins into the bushings on the inner backlinks at the two ends.
four.Confirm that the grease is applied towards the whole encounter of the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins to the connecting plate and though pressing the connecting plate, install the spring clip. Confirm regardless of whether the head (the end with no split) of the spring clip is turned during the feeding route from the chain. (See the following illustration.)
six.Make sure to confirm the spring clip is securely fitted inside the clip grooves of the connecting pins.
This completes jointing in the connecting website link. Note that grease over the surfaces of connecting pins and O-rings could be eliminated all through installation get the job done. In this case, re-grease working with the grease on the surface on the base chain or the grease inside the polyethylene bag by which the connecting hyperlink was contained.